Wiring Methods
10 articles
-
Attic Wiring Needs Support and Extra Protection Where It Can Be Stepped On or Stored Against
Does Romex in an attic need to be protected?
E3802.2
-
Cable Bends Must Not Damage the Sheath or Conductors
How tight can I bend Romex around a corner?
E3802.5
-
Crawlspace Cable Must Be Rated for the Location and Protected from Damage
Can Romex be run in a crawlspace?
E3802.4
-
Garage Cable Needs Protection Where It Is Exposed to Physical Damage
Does Romex in a garage have to be in conduit?
E3802.3.2
-
Junction Boxes Must Remain Accessible After the Wall or Ceiling Is Finished
Can I bury a junction box behind drywall?
E3802.1
-
Nail Plates Are Required Where Cable Is Too Close to a Framing Edge
When do I need nail plates over Romex?
E3802.3.2
-
NM Cable Can Run Through Framing When It Is Protected and Supported
Can you run Romex through studs without conduit?
E3801.2
-
NM Cable Must Be Secured Within 12 Inches of Boxes and Every 4 1/2 Feet
How often does Romex have to be stapled?
E3802.6
-
Raceways Crossing Temperature Zones Need Sealing Against Condensation Movement
Do I need to seal conduit where it goes from inside to outside?
E3802.7
-
Underground Wiring Needs the Required Cover and Damage Protection
How deep does underground electrical conduit or cable have to be?
E3803.1
Have a code question about your project? Get personalized answers from our team — $9/mo.
Membership